? You are here:home > Industry news > Pruduct's Detail
The high frequency heating the material used to
High-frequency diathermy
To?do a simple?introduction in this regard
The sensor?consists of the following parts:
1,?the contact plate:?also known as the?bus,?the two?coil is connected with?front end and the quenching furnace? transformer?it,?rear end and the?effective coil?welded together.?Two pieces of?the contact plate?there aresy mmetrical,?the?current?loop,?the insulation?plate?with mica plate?manufactured?between two?contact plate.
2,?cooling water?box:?each?contact plate?welding?a?cooling water?box,?contact?with?cooling?plate.
3,?the contact plate?fastening bolt:?insulation board?using the two?fastening bolts?and?the?two?contact plate,?boltwith?brass rod to manufacture,?use?and?bakelite?washer and a?bakelite?casing,?the insulating?bolt?and the contact plate.?If?the contact plate?when the?temperature is nothigh,?the fastening bolt?available nylon?manufacturing.
4,?a positioning ring?plate:?fabric?manufacturing,?used forclamping and positioning?ring,?so as to be insulated from the?sensor body.
5,?a positioning ring:?for quenching?parts of the?axial positioning and radial?limit,?when the?six party?componentsat the top of the?cap?on the locating ring,?to ensure that the?axial?parts quenching?zone distribution?accurately.
6,?plate?fastening bolt:?used for?pressing and?sensors?onthe flange between the?fastening,?ensure the positioningring location?accuracy.
7,?the flange:?made of?copper,?welding and?effective coiland the water jacket,?so as to form a?quenching?water cavity,?and?positioning?fixture?of?Ch.
8,?effective?circle:?to?form a magnetic field,?and?themagnetic field?directly for?conductor?heating?workpiece?is called the effective?coil?or?conductor,?if effectiveconductor?is a?copper tube?can also be called?the effective wire.?It?and the contact plate?is firmly welded?together.Henan Chao?Feng electrical equipment?limited company?is morerefined?sensors of various?types
9,?the quenching?water:?its full name?should be thequenching water?inlet pipe,?quenching?water through it?into the?quenching?water cavity,?quenching?water pipe and thewater jacket?is welded together.
10,?the quenching?water:?when the parts are?heated toquenching temperature,?quenching?water?quenching?water?into the?quenching?water cavity,?then from?quenching?water?spray out,?make?parts quenching.
The 11,?sensor positioning?hole:?drill in the?contact platesurface,?when the sensor?installation,?fixed bolts?quenched transformer?two?coil?out?from the fixed?Kong Shen,?tighten the nut,?ensure the contact?plate and the?transformer?coilcontact plate?good?level two.
12,?cooling water pipe:?with?high frequency furnace
Welding?in the cooling water?box,?a.
13,?the limiting plate?on the?lower end?of?the parts:?radiallimit.
Believe to pass the introduction of above?we can?more?deeper understanding?in detail?Henan Chao?Feng electrical?websitehttp://www.yunjiangbang.com
Tags: on-product information